CLI Command
Creating IPX Static Services
Web Agent
Procedure
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
To modify an IPX static route using the CLI, enter the following
command Interface mode:
(config-if:<if-name>)# ipx route <network address
| range> <options>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3.1 for details about this
command.
You can create IPX static services using either the Web Agent or the
CLI.
To create IPX static services using the Web Agent:
1. Select Static Services from the Routing > IPX >
Configuration group on the Web Agent window. The IPX
Static Services dialog box opens (see Figure 12-9).
Figure 12-9. IPX static Services Dialog Box
2. Select CREATE to create a new static service. The Add IPX
Static Service dialog box opens (see Figure 12-10).
* Note: Only the Create button is shown if no IPX Static Services
are configured.
Configuring IPX Routing
12-13