Avaya Cajun P882 User Manual page 421

Using the Web
Using the CLI
Using the CLI
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1
interface as a stub network in the router updates it sends to other
OSPF interfaces.
You can set OSPF passive-interface using either the Web Agent or
the CLI.
You can set OSPF passive-interface from the OSPF Interface web
page. The Interface-State field on the OSPF Interface web page can
be set to Passive, which disables the sending of OSPF routing
updates. Normal, which enables the sending of OSPF routing
updates, is the default.
You can set OSPF Passive Interface from the CLI using the
commands:
This command defines an OSPF interface as passive-interface.
>passive-interface [<interface-name>|
<ip-addr>]
This command sets the state of an OSPF interface that is configured
as a passive-interface to normal.
>no passive-interface [<interface-name>|
<ip-addr>]
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, v5.3 for details about this command.
To modify an OSPF interface using the CLI, enter the following
command from Configure/Interface mode:
(config-if: <interface>) ip ospf <options>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, v5.3 for details about this command.
Configuring the OSPF Routing Protocol
11-13