Avaya Cajun P882 User Manual page 419

Parameter
Select
Interface
IP Address
Area
DR Priority
Transmit Delay
Retransmit
Interval
Hello Interval
Dead Interval
Poll Interval
Cost
Authentication
Key
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1
e. Click Apply.
Table 11-3. OSPF Interface Dialog Box Parameters
Definition
Select the OSPF interface to be modified.
Displays IP interface (VLAN) that has OSPF enabled.
Note:
This is a read-only field.
Displays IP address associated with the OSPF interface.
Note:
This is a read-only field.
Enter the area ID configured for this interface. The default is
0.0.0.0.
Enter the decimal value for this interface for DR priority
functionality. The value range is 0-255. The default is 1.
Enter the estimated time (seconds) it takes to transmit a link state
update packet over this interface.The value range is 1-3600. The
default is 1.
Enter the time (seconds) between link-state advertisement
retransmissions, for adjacencies belonging to this interface. This
value is also used when retransmitting database description and
link-state request packets. The value range is 1-3600. The default is
5.
Enter the time (seconds) between the Hello packets that the router
sends on the interface. This value must be the same for all routers
attached to a common network. The value range is
1-65535. The default is 10.
Enter the time (seconds) that a router's Hello packets have not been
seen before it's neighbors declare the router down. This should be
some multiple of the Hello interval. This value must be the same for
all routers attached to a common network. The value range is 1-
65535. The default is 40.
Enter the larger time interval (seconds) between the Hello packets
sent to an inactive non-broadcast multiaccess neighbor. he value
range is 1-65535. The default is 120.
Enter the cost metric associated with this interface. The value range
is 1-65535. The default is 1.
Select the type of authentication available for use on a given OSPF
interface. Authentication types are:
• None (default)
• Simple Password
• MD5 Authentication
Enter the authorization key value for the interface.
Configuring the OSPF Routing Protocol
11-11