Using The Event Subsystem - Avaya Cajun P882 User Manual

Multiservice switch

Hide thumbs Also See for Cajun P882:

Table of Contents

Using the CLI

Using the Event Subsystem

Figure 17-2. Active Alarm Table Dialog Box

To view the Active Alarm Table using the CLI, enter the following

command from Configuration mode:

<configure># show alarms

Refer to the Command Reference Guide for the Avaya P550R, P580, P880,

and P882 Multiservice Switches, v5.3.1 for details about this command.

There are two switch system activity logs:

Event Log - stores a large table of events. The size of the table

is user-settable. Because these events are stored in switch

memory, the list is cleared each time the switch reboots.

Shutdown Log - stores the same information as the Event Log,

but generally in a smaller table because the table is stored in the

switch's nonvolatile RAM (NVRAM). This log list is particularly

useful in assessing the cause of a switch failure, because the

information is retained even after the switch restarts.

* Note: The following events are now logged in the event log:

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1

P550r P580 P880