Setting Up Nbma Neighbors - Avaya Cajun P882 User Manual

Multiservice switch

Hide thumbs Also See for Cajun P882:

Table of Contents

CLI Commands

Setting Up NBMA Neighbors

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1

To use the CLI to set up an NBMA IP interface:

1. Enter Configuration mode. The CLI displays the following

<configure>#

For information on how to enter this mode, see "Accessing/Exiting

the Command Modes" in Chapter 1, "Overview," of the Command

Reference Guide for the Avaya P550R, P580, P880, and P882 Multiservice

Switches, v5.3.

2. Enter the following command at the prompt:

<configuration># interface <interface-name>

The following prompt displays:

(configure-if:<interface-name>)#

3. Enter the following command at the prompt:

(configure -if: <interface-name>)# ip address <ip-addr>

4. Enter the following command at the prompt:

(configure -if: <interface-name>)# type nbma

To use the Web Agent to set up NBMA neighbors:

1. Open the Routing > IP > RIP or OSPF folders, whichever

one was created with an NBMA type interface.

2. Click NBMA Neighbors. The RIP or OSPF NBMA Neighbors

Web page opens.

3. Click Create. The Add NBMA RIP or OSPF Neighbor Web

4. Enter a neighbor IP interface address in the Network

Address field.

5. Click CREATE, or CANCEL to restore previous setting.

Configuring the OSPF Routing Protocol

P550r P580 P880