Avaya Cajun P882 User Manual page 457

CLI Command
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Table 12-4. IPX Static Route Parameters continued
Parameter Allows you to...
Ticks Enter the amount of time (in ticks) that the packet
takes to reach the network number you specified. A
tick is approximately 1/18th of a second.
Hops Enter the number of routers (hops) that the packet
must pass through before reaching the network
number associated with the IPX network.
5. Click APPLY to save your changes, or CANCEL to restore
previous settings.
6. To view or modify IPX Static Routes, select Static Routes from
Routing > IPX > Configuration group on the Web Agent
window. The configured IPX Static Routes dialog box opens
(Figure 12-8)
*Note: It is also possible to create a static route by,
making a RIP source route from the IPX Static
Route Table.
Figure 12-8. IPX Static Routes Dialog Box
To create IPX static routes using the CLI, enter the following
command in Interface mode:
(config-if:<if-name>)#: ipx route <network
address | range> <options>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3.1 for details about this
command.
Configuring IPX Routing
12-11