Disabling A Module; Configuring 10/100/1000 Mbit/S 9048Gt Ethernet Ports With Autonegotiation - Avaya Virtual Services Platform 9000 Series Configuration Manual

Ethernet module configuration using ACLI

Disabling a module

Prerequisites
You must log on to the Global Configuration mode in ACLI.
Disable an Ethernet module before you remove it from the chassis to minimize traffic loss.
Traffic does not flow on a disabled module.
Disable a module:
slot shutdown {slot[-slot][,...]}
Variable definitions
Use the data in the following table to use the slot shutdown command.
Table 6: Variable definitions
{slot[-slot][,...]}
Configuring 10/100/1000 Mbit/s 9048GT Ethernet ports with
Autonegotiation
Prerequisites
You must log on to the Interface Configuration mode in ACLI.
Important:
If a port belongs to a MultiLink Trunking (MLT) group and you configure CANA on the port
(that is, you configure an advertisement other than the default), you must apply the same
configuration to all other ports of the MLT group (if they support CANA).
If a 10/100/1000 Mbit/s port that supports CANA is in a MLT group with 10/100BASE-TX
ports, or an other port type that does not support CANA, use CANA only if it does not conflict
with MLT abilities.
26 Configuration — Ethernet Modules
Variable Value
Specifies one or more slot numbers.
June 2011