Viewing Information About A Fabric Mode 2 Port Mirror; Setting Up A Port Mirror By Using Snmp - Avaya Cajun P882 User Manual

Multiservice switch

Hide thumbs Also See for Cajun P882:

Table of Contents

Viewing Information about a Fabric Mode 2 Port Mirror

Setting Up Port

To remove a port mirror from a switch in Fabric mode 2, use the

following CLI command from configure mode:

<configure># clear port mirror Fabric_mode2

channel <channel>

For more information about this command see "set port mirror

Fabric_mode2" in Chapter 21, "Port," of the Command Reference Guide

for the Avaya P550R, P580, P880, and P882 Multiservice Switches, v5.3.1.

To view information about a Fabric mode 2 port mirror:

1. Expand the Modules & Ports folder.

2. Click Port Mirroring.

The Port Mirroring Information page opens. This page displays

information about all port mirrors that are setup.

To view information about a Fabric mode 2 port mirror, use the

following CLI command:

<configure># show port mirror Fabric_mode2

This command displays the source ports, mirror port, direction being

mirrored, sampler type, and maximum packet per second for all port

mirrors that are currently set up.

The MIB objects that you use to configure 80-series port mirroring

are located in the RFC2613 MIB and the cjnPortCopyExtensions

* Note: (RN000075) If you attempt to set up port mirroring on a

port that is administratively disabled, and you configure

the disabled port as a source or mirror port, note the

Traffic sent to a disabled source port will be lost. A

disabled port set up as a mirror port will not be able to

send any traffic to a monitoring device.

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1

P550r P580 P880