Parameter
SAP
Type 20 Packet
Propagation
CLI Command
Creating IPX Static Routes
Web Agent
Procedure
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Table 12-3. IPX Interface Dialog Box Parameters
Allows you to...
Select Disable to prevent IPX SAP from routing globally.
This affects all IPX interfaces set up to use the IPX SAP
routing protocol. The default value is Enable.
Specify whether or not Type 20 packets can be sent,
received, disabled, or sent and received on a given
interface.
Options include:
Disable - Type 20 packets are neither sent nor received.
Inbound - Type 20 packets are received.
Outbound - Type 20 packets are sent.
Both - Type 20 packets are sent and received.
The default value is Disable
To begin the creation of a new IPX interface using the CLI, enter the
following command in Configure mode:
<configure># interface <interface name>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3.1 for details about this
command.
You can create IPX static routes using either the Web Agent or the
CLI.
To create IPX static routes using the Web Agent:
1. Select Static Routes from Routing > IPX > Configuration
group on the Web Agent window. The IPX Static Routes
dialog box opens (see Figure 12-6).
Configuring IPX Routing
2 of 2
12-9