Avaya Cajun P882 User Manual page 136

Chapter 4
Binding a Port
to more than
one VLAN using
the CLI
CAUTION
4-6
3. Setting the VLAN Binding attribute in the Switch Port
Configuration dialog box to Bind to Received. This causes
the port to be bound to all VLANs (as identified by the VLAN
tag in tagged frames) received on this port. Consequently,
ports are bound to those VLANs that actually have members
that are reachable through the port.
*Note: When an untagged frame arrives on a port that is
set to Bind to ALL, it forwards the frame to the
"port VLAN". When a tagged 802.1Q frame
arrives on a port that is set to Bind to All and the
VLAN doesn't exist on the switch the frame is
dropped.
Ingress: Untagged frames are classified to the
VLAN associated with the port on which the frame
is received. Tagged frames are classified to the
VLAN identified by the VLAN tag in the tag header
of the frame.
Forwarding: Only forward frames to the port for
the assigned VLAN.
Egress: All frames transmitted out of the port to
be tagged using the IEEE 802.1Q/Multi-Layer tag
header format. The tagged used will be that
assigned to the port.
A port can be statically configured to Bind to more than one VLAN.
This causes the port to become a member of each specified VLAN.
This feature is configured from the CLI. This feature cannot be
configured from the Web Agent.
To configure from the CLI enter the following command:
<configure># set VLAN{<VLAN-id> | name <VLAN-name>}
<mod-swport-range>[...,<mod-swport-range>]
This configuration should only be used under special circumstances
and with the assistance of customer support.
* Note: The Web Agent does not allow static binding of multiple
VLANs to a single port. If you use the CLI to statically
bind multiple VLANs to a single port, do not attempt to
use the Web Agent to statically bind additional VLANs to
the port or remove existing VLANs from the port.
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1