Renaming A Receiver Or Transmitter - Extron electronics AXI 22 AT User Manual

9. Click Yes (
box. The new name is written to the AXI. Repeat as necessary for all devices.
NOTE: The device name assigned in Dante Controller also applies to the device
name recognized in DSP Configurator Software.
Figure 20.

Renaming a Receiver or Transmitter

In addition to renaming devices, individual Receiver and Transmitter channels can be
renamed in Dante Controller. To better organize the various Receivers and Transmitters, it
is recommended each Receiver and each Transmitter be named using a description of the
device they belong to, the location of the device, or the purpose of the channel.
TIP:
subscriptions are established. Existing subscriptions are removed when Transmitter
channels are renamed.
To view the Receiver or Transmitter channels in Dante Controller, click the + sign next to the
Receiver or Transmitter device name to expand it. The + sign becomes a - sign when the
device is expanded (see figure 21,
Figure 21.
Renaming a Receiver
The default names shown in the Dante Receivers column are extracted from the
connected Dante device (
Analog Out 4 because the analog outputs receive signal from the Dante network.
) to confirm the new name, then close the Device Configuration dialog
4
Rename Device Confirmation Dialog Box
It is essential that Dante Transmitter channels be named before audio
).
1
Expanded Receivers and Transmitters
). The AXI Receivers are labelled Analog Out 1 through
1
AXI 22 AT and AXI 44 AT • Dante Controller 22