External I/O Signal Display - Mitsubishi MR-JE-200A Instruction Manual

3. DISPLAY AND OPERATION SECTIONS

3.1.7 External I/O signal display

The on/off states of the digital I/O signals connected to the servo amplifier can be confirmed.
(1) Operation
The display at power-on. Switch to the diagnostic display with the "MODE" button.
(2) Display definition
The 7-segment LED segments and CN1 connector pins correspond as shown below.
CN1-42
Input signals
Always lit
Output signals
Note 1. This is available with servo amplifiers manufactured in May 2015 or later.
2. CN1-10 pin and CN1-37 pin are mutually exclusive, and CN1-35 pin and CN1-38 pin are mutually exclusive.
The LED segment corresponding to the pin is lit to indicate on, and is extinguished to indicate off.
For each pin signal in control modes, refer to section 2.2.
POINT
The I/O signal settings can be changed using I/O setting parameters [Pr. PD04]
to [Pr. PD28].
CN1-10 CN1-35
(Note 2)/ (Note 2)/
CN1-37 CN1-38
(Note 1, 2) (Note 1, 2)
CN1-33
Press "UP" twice.
...... External I/O signal display screen
CN1-41 CN1-19
CN1-48
3 - 19
CN1-15 CN1-44 CN1-43
CN1-23 CN1-24 CN1-49
Light on: on
Light off: off