Mitsubishi MR-JE-200A Instruction Manual page 339

7. PARAMETERS
No./symbol/ Setting
name digit
PT21
*LNPL
Position
range output
address -
(lower three
digits)
PT22
*LNPH
Position
range output
address -
(upper three
digits)
PT23
OUT1
OUT1 output
setting time
PT24
OUT2
OUT2 output
setting time
PT25
OUT3
OUT3 output
setting time
Set an address decreasing side of the position range output address.
Upper and lower are a set. Set a range which POT (Position range) turns on with [Pr.
PT19] to [Pr. PT22].
Setting address:
Upper 3 Lower 3
digits
The unit will be changed to 10
the setting of [Pr. PT01].
Set a same sign for [Pr. PT21] and [Pr. PT22]. Setting a different sign will trigger [AL.
37 Parameter error].
When changing the setting, be sure to set the lower three-digit data first and then the
upper three-digit data.
When changing the direction to address increasing, change it from the + side of the
position range output address ([Pr. PT19] and [Pr. PT20]). An incorrect order of the
setting will trigger [AL. 37]. Therefore, cycling power may be required after [Pr. PT19]
to [Pr. PT22] are all set.
Setting range: -999999 to 999999
Set an output time for when OUT1 (Program output 1) is turned on with the OUTON
command.
Setting "0" will keep the on-state. To turn it off, use the OUTOF command.
Setting range: 0 to 20000
Set an output time for when OUT2 (Program output 2) is turned on with the OUTON
command.
Setting "0" will keep the on-state. To turn it off, use the OUTOF command.
Setting range: 0 to 20000
Set an output time for when OUT3 (Program output 3) is turned on with the OUTON
command.
Setting "0" will keep the on-state. To turn it off, use the OUTOF command.
Setting range: 0 to 20000
Function
digits
[Pr. PT21]
[Pr. PT22]
STM [μm], 10 (STM-4) [inch], 10 -3
7 - 64
Function
[degree], or [pulse] with
Control
Initial
mode
value
[unit]
CP CL
0
Refer to
column
for unit.
0
[ms]
0
[ms]
0
[ms]