Cam Position Compensation Time Constant - Mitsubishi MR-JE-200A Instruction Manual

6. APPLICATION OF FUNCTIONS

6.1.16 Cam position compensation time constant

The compensation amount calculated when cam position compensation is requested is divided into the time
set in [Cam control data No. 61 Cam position compensation time constant] and used for compensation.
C_CPCD
(Cam position compensation
request)
S_CPCC
(Cam position compensation
execution completed)
Cam axis one cycle
current value
POINT
Use C_CPCD (Cam position compensation request (bit 13 of 2D02h)) to input a
cam position compensation request via the Modbus RTU communication. Use
S_CPCC (Cam position compensation execution completed (bit 13 of 2D12h)) to
read the output status of Cam position compensation execution completed.
C_CPCD and S_CPCC are available with servo amplifiers with software version
C1 or later. For details, refer to "MR-JE-_A Servo Amplifier Instruction Manual
(Modbus RTU communication)".
Cam position compensation
time constant
6 - 51
Cam position compensation
target position
With time constant
Without time constant