Mitsubishi MR-JE-200A Instruction Manual page 59

3. DISPLAY AND OPERATION SECTIONS
Name
Software version: lower
Software version: upper
Automatic VC offset (Note)
Servo motor series ID
Servo motor type ID
Servo motor encoder ID
For manufacturer adjustment
For manufacturer adjustment
Teaching function
Note. Even if VC automatic offset is performed and 0 V is inputted, the speed may not completely be the set value.
Display
Refer to section 3.1.10.
3 - 10
Description
Indicates the version of the software.
Indicates the system number of the software.
If offset voltages in the analog circuits inside and outside
the servo amplifier cause the servo motor setting speed not
to be the designated value at VC of 0 V, a zero-adjustment
of offset voltages will be automatically performed. When
using the VC automatic offset, enable it in the following
procedures. When it is enabled, [Pr. PC37] value changes
to the automatically adjusted offset voltage.
1) Press the "SET" button once.
2) Set the number in the first digit to "1" with the "UP"
button.
3) Press the "SET" button.
This function cannot be used if the input voltage of VC is -
0.4 V or less, or +0.4 V or more.
Push the "SET" button to show the series ID of the servo
motor currently connected.
For indication details, refer to app. 1 of "HF-KN/HF-SN
servo Motor Instruction Manual".
Push the "SET" button to show the type ID of the servo
motor currently connected.
For indication details, refer to app. 1 of "HF-KN/HF-SN
servo Motor Instruction Manual".
Push the "SET" button to show the encoder ID of the servo
motor currently connected.
For indication details, refer to app. 1 of "HF-KN/HF-SN
servo Motor Instruction Manual".
This is for manufacturer adjustment.
This is for manufacturer adjustment.
After an operation travels to a target position (MEND
(Travel completion) is turned on) with a JOG operation or
manual pulse generator operation, pushing the "SET"
button of the operation part or turning on TCH (Teach) will
import position data. This function is available only in the
point table method. In other control modes, the display
remains the same.