Clear Lldp Config All; Lldp Admin-State - Hirschmann RS20 Reference Manual

4.8.20 clear lldp config all

Clear the LLDP configuration, i. e., set all configurable parameters to default
values (all chassis- as well as port-specific parameters at once). Note: LLDP
Remote data remains unaffected.
Format
clear lldp config all
Mode
Privileged EXEC

4.8.21 lldp admin-state

Configure the port's LLDP admin state (if LLDP/IEEE802.1AB frames will be
transmitted to and/or received from the standard IEEE multicast address
01:80:c2:00:00:0e).
The default setting is tx-and-rx.
Format
lldp admin-state <{tx-only|rx-only|tx-and-rx|off}>
Mode
Interface Config
156
4.8 LLDP - Link Layer Discovery Protocol
CLI L2B
Release 4.0 11/07