Hirschmann RS20 Reference Manual page 24

Quick Start up
Command
users passwd <user
name>
(in Global Config)
copy system:running-
config nvram:star
tup-config
(in Privileged EXEC)
logout
(in User EXEC and Privileged
EXEC)
Table 10: Quick Start up User Account Management
Quick Start up IP Address
To view the network parametes the operator can access the device by the
following two methods.
D
Simple Network Management Protocol - SNMP
D
Web Browser
24
2.2 System Info and System Setup
Details
Allows the user to set passwords or change passwords
needed to login
A prompt will appear after the command is entered
requesting the users old password. In the absence of an
old password leave the area blank. The operator must
press enter to execute the command.
The system then prompts the user for a new password
then a prompt to confirm the new password. If the new
password and the confirmed password match a message
will be displayed.
User password should not be more than eight characters in
length.
This will save passwords and all other changes to the
device.
If you do not save the configuration by doing this com-
mand, all configurations will be lost when a power cycle is
performed on the switch or when the switch is reset.
Logs the user out of the switch
CLI L2B
Release 4.0 11/07