Set Igmp - Hirschmann RS20 Reference Manual

4.5.7

set igmp

This command enables IGMP Snooping on the system. The default value is
disable.
Note: The IGMP snooping application supports the following:
D
Global configuration or per interface configuration.
D
Validation of the IP header checksum (as well as the IGMP header check-
sum) and discarding of the frame upon checksum error.
D
Maintenance of the forwarding table entries based on the MAC address
versus the IP address.
D
Flooding of unregistered multicast data packets to all ports.
Format
set igmp
Mode
Global Config
no set igmp
U
This command disables IGMP Snooping on the system.
Format
no set igmp
Mode
Global Config
104
4.5 Device Configuration Commands
CLI L2B
Release 4.0 11/07