Show Network - Hirschmann RS20 Reference Manual

CLI Commands: Base
4.3.9

show network

This command displays configuration settings associated with the switch's
network interface. The network interface is the logical interface used for in-
band connectivity with the switch via any of the switch's front panel ports.
The configuration parameters associated with the switch's network interface
do not affect the configuration of the front panel ports through which traffic is
switched or routed.
Format
show network
Mode
Privileged EXEC and User EXEC
IP Address
The IP address of the interface. The factory default value is 0.0.0.0
Subnet Mask
The IP subnet mask for this interface. The factory default value is
0.0.0.0
Default Gateway
The default gateway for this IP interface. The factory default value is
0.0.0.0
Burned In MAC Address
The burned in MAC address used for in-band connectivity.
Network Configuration Protocol (BootP/DHCP)
Indicates which network protocol is being used. The options are
bootp | dhcp | none.
DHCP Client ID (same as SNMP System Name)
Displays the DHCP Client ID.
Network Configuration Protocol HiDiscovery
Indicates in which way the HiDiscovery protocol is being used. The
options are off | read-only | read-write.
Management VLAN IP-DSCP Value
Specifies the management VLAN IP-DSCP value.
Java Script Mode
Specifies if the Switch will use Java Script to start the Management
Applet. The factory default is enabled.
70
4.3 Management Commands
CLI L2B
Release 4.0 11/07