Mode-Based Cli - Hirschmann RS20 Reference Manual

Mode-based CLI

3 Mode-based CLI
The CLI groups all the commands in appropriate modes according to the na-
ture of the command. A sample of the CLI command modes are described
below. Each of the command modes support specific Hirschmann software
commands.
D
User Exec Mode
D
Privileged Exec Mode
D
Global Config Mode
D
Interface Config Mode
D
Line Config Mode
The Command Mode table captures the command modes, the prompts visi-
ble in that mode and the exit method from that mode.
Command Mode
User Exec Mode
Privileged Exec
Mode
Global Config
Mode
Interface Config
Mode
Line Config Mode From the Global Con-
Table 14: Command Mode
CLI L2B
Release 4.0 11/07
Access Method
This is the first level of
access. Perform basic
tasks and list system
information
From the User Exec
Mode, enter the
enable command
From the Privileged
Exec mode, enter the
configure com-
mand
From the Global Con-
figuration mode, enter
the interface
<slot/port> com-
mand
figuration mode, enter
the lineconfig
command
Prompt Exit or Access Next Mode
Enter Logout command
(Hirschmann
PowerMICE)>
To exit this mode, enter exit
(Hirschmann
or press Ctrl-Z.
PowerMICE)#
To exit to the Privileged
(Hirschmann
Exec mode, enter the exit
PowerMICE)
command, or press Ctrl-Z to
(Config)#
switch to user exec mode.
To exit to the Global Config
(Hirschmann
mode enter exit. To return to
PowerMICE)
user EXEC mode enter ctrl-
(Interface-
Z.
"if num
ber")#
To exit to the Global Config
(Hirschmann
mode enter exit. To return to
PowerMICE)
User Exec mode enter ctrl-
(line) #
Z.
27