Ping; Signal-Contact - Hirschmann RS20 Reference Manual

4.7.15 ping

This command checks if another computer is on the network and listens for
connections. To use this command, configure the switch for network (in-
band) connection. The source and target devices must have the ping utility
enabled and running on top of TCP/IP. The switch can be pinged from any IP
workstation with which the switch is connected, as long as there is a physical
path between the switch and the workstation. The terminal interface sends,
three pings to the target station.
Format
ping <
ipaddr>
Mode
Privileged EXEC and User EXEC

4.7.16 signal-contact

This command configures the signal contact link error monitoring for this port.
Format
signal-contact connection-error {disable|enable}
Mode
Interface Config
4.7.17 signal-contact
This command configures the signal contacts.
Format
signal-contact {1|2|all}
CLI L2B
Release 4.0 11/07
4.7 System Utilities
141