Hirschmann RS20 Reference Manual page 31

Mode-based CLI
Interface Config Mode
Many features are enabled for a particular interface. The Interface
commands enable or modify the operation of an interface.
In this mode, a physical port is set up for a specific logical connection
operation. The Interface Config mode provides access to the router
interface configuration commands. The command prompt at this level
is:
Command Prompt: (Hirschmann PowerMICE)(Interface
<slot/port>)#
The resulting prompt for the interface configuration command entered
in the Global Configuration mode is shown below:
(Hirschmann PowerMICE)(Config)# interface 2/1
(Hirschmann PowerMICE)(Interface 2/1)#
Line Config Mode
This mode allows the operator to configure the console interface. The
operator may configure the interface from the directly connected con-
sole. The command prompt at this level is:
Command Prompt: (Hirschmann PowerMICE)(Line)#
CLI L2B
Release 4.0 11/07
3.2 Mode-based Command Hierarchy
31