Hirschmann RS20 Reference Manual page 44

CLI Commands: Base
Alignment Errors - The total number of packets received that had a
length (excluding framing bits, but including FCS octets) of between
64 and 1518 octets, inclusive, but had a bad Frame Check Sequence
(FCS) with a non-integral number of octets.
Rx FCS Errors - The total number of packets received that had a
length (excluding framing bits, but including FCS octets) of between
64 and 1518 octets, inclusive, but had a bad Frame Check Sequence
(FCS) with an integral number of octets
Overruns - The total number of frames discarded as this port was
overloaded with incoming packets, and could not keep up with the
inflow.
Received Packets not forwarded
Total - A count of valid frames received which were discarded (i.e. fil-
tered) by the forwarding process.
Local Traffic Frames - The total number of frames dropped in the
forwarding process because the destination address was located off
of this port.
802.3x Pause Frames Received - A count of MAC Control frames
received on this interface with an opcode indicating the PAUSE oper-
ation. This counter does not increment when the interface is operating
in half-duplex mode.
Unacceptable Frame Type - The number of frames discarded from
this port due to being an unacceptable frame type.
Reserved Address Discards - The number of frames discarded that
are destined to an IEEE 802.1 reserved address and are not sup-
ported by the system.
Broadcast Storm Recovery - The number of frames discarded that
are destined for FF:FF:FF:FF:FF:FF when Broadcast Storm Recovery
is enabled.
CFI Discards - The number of frames discarded that have CFI bit set
and the addresses in RIF are in non-canonical format.
Upstream Threshold - The number of frames discarded due to lack
of cell descriptors available for that packet's priority level.
Packets Transmitted Octets
Total Bytes - The total number of octets of data (including those in
bad packets) received on the network (excluding framing bits but
including FCS octets). This object can be used as a reasonable esti-
mate of ethernet utilization. If greater precision is desired, the ether-
44
4.1 System Information and Statistics Com-
CLI L2B
Release 4.0 11/07