Hirschmann RS20 Reference Manual page 25

Quick Start up
Note: Helpful Hint: The user should do a 'copy system:running-config
nvram:startup-config' after configuring the network parameters so that the
configurations are not lost.
Command
show network
(in User EXEC)
network parms
(in Privileged EXEC)
Table 11: Quick Start up IP Address
CLI L2B
Release 4.0 11/07
Details
Displays the Network Configurations
IP Address - IP Address of the switch
Default IP is 0.0.0.0
Subnet Mask - IP Subnet Mask for the switch
Default is 0.0.0.0
Default Gateway - The default Gateway for this switch
Default value is 0.0.0.0
Burned in MAC Address - The Burned in MAC Address used for
in-band connectivity
Network Configurations Protocol (BOOTP/DHCP) - Indicates
which network protocol is being used
Default is DHCP
Network Configurations Protocol HiDiscovery - Indicates the sta-
tus of the HiDiscovery protocol.
Default is read-write
Web Mode - Indicates whether HTTP/Web is enabled.
JavaScript Mode - When the user accesses the switch's web
interface and JavaScript Mode is enabled, the switch's web
server will deliver a HTML page that contains JavaScript. Some
browsers do not support JavaScript. In this case, a HTML page
without JavaScript is necessary. In this case, set JavaScript Mode
to disabled.
Default: enabled.
network parms <ipaddr> <netmask>
[gateway]
IP Address range from 0.0.0.0 to 255.255.255.255
Subnet Mask range from 0.0.0.0 to 255.255.255.255
Gateway Address range from 0.0.0.0 to 255.255.255.255
2.2 System Info and System Setup
25