Show Running-Config - Hirschmann RS20 Reference Manual

CLI Commands: Base
Signal contact trap
enabled A trap is sent if the signal contact state changes.
disabled No trap is sent if the signal contact state changes.
Note: To show the signal contact´s port related settings, use the command
show port {<slot/port> | all} (see

4.1.13 show running-config

This command is used to display the current setting of different protocol
packages supported on the switch. This command displays only those
parameters, the values of which differ from default value. The output is
displayed in the script format, which can be used to configure another switch
with the same configuration.
Format
show running-config [all]
Mode
Privileged EXEC
all
Show all the running configuration on the switch. All configuration
parameters will be output even if their value is the default value.
52
4.1 System Information and Statistics Com-
"show port" on page 116).
CLI L2B
Release 4.0 11/07