Sanyo SUPER BL P5 Manual page 93

6. OPERATION
Push the
appear.
(Func6 bit6 "1" described above returns to "0" by
turning the power on again.)
10 Turn on the 200 VAC (② wires) of R-S-T.
The 7-segment LED is light as shown in the right
figure.
11 Start the JOG operation.
Push the
right screen will appear.
Push the
right screen will appear.
The 7-segment LED draws a figure of 8.
Continue pushing the
screen appears.
The remote operator keeps sounding "beep, beep"
and the motor rotates counterclockwise (CCW) in
10 min
Then continue pushing the
screen appears.
In this mode, the motor rotates clockwise (CW) in
10 min
key so that the right screen will
and
, 1 and
key until the right
− 1
when viewed from its shaft side.
− 1
.
keys so that the
7
keys so that the
key until the right
6－11
Completed 7
Func6 : 01000000
WR
＊Test 0
-1
JOG Set min
＊Test 0
-1
JOG Set 10min
WR
0
＊Test
JOG Fwd Running
＊Test 10
JOG Rvs Running