Structure Of The Control Panel - Sanyo SUPER BL P5 Manual

10. INTERNATIONAL STANDARDS

10.2.3 Structure of the Control Panel

1. A metallic material is used for the control panel and its cover.
2. The joint of the roof and the side board shall be masked and welded.
3. The joint fixed with screws shall be welded to prevent noise from leaking from the gap in the joint.
4. In case of fixing with screws or spot welding, the welding space shall be within 10 cm.
5. Use an EMI gasket to prevent clearance between the cover and the control panel.
6. The EMI gasket shall be installed uniformly on the joint section of the cover and the control panel.
7. Perform a conductivity test on the EMI gasket, the cover and the control panel to make sure that they
are conductive.
Cover
EMI gasket
Control panel
Perform a conductivity test on the joint
section of the EMI gasket
10－5
Welding processing