Motor Mechanical Specifications - Sanyo SUPER BL P5 Manual

9. SPECIFICATIONS
9.2.3

Motor Mechanical Specifications

(1) Vibration resistance
Install the Servomotor shaft horizontally as shown in Fig. 9-25 and apply vibration in 3 directions,
up/down, left/right and back/forth. At this time, the Servomotor should withstand a vibration
acceleration of 2.5G.
Back and forth
(2) Shock resistance
Install the motor shaft in the horizontal direction as shown in Fig. 9-26 and apply a shock in the up/down
direction. At this time, the Servomotor should withstand an impact acceleration of 10G up to 2 times.
However, since the Servomotor is provided with a precision detector on the counter-load side, if a shock
is applied to the shaft, the detector may be damaged. So do not apply shock to the shaft under any
circumstances.
Horizontal derection
Fig. 9-25 Vibration Resistance Measurement
Horizontal derection
Fig. 9-26 Shock Measurement
Up and down
Up and down
9－60
Right and left