6. OPERATION
6.3.2
Jog Operation
7
Turn ON the 200 VAC of r-t (① wires).
→
The servo amplifier POWER and the right-hand
figure portion of 7-segment LED are lighted.
→
When the 7-segment LED displays "U", proceed to
section 6.4.
→
The remote operator screen display becomes the
[Push Mode Key] screen as shown on the right and
a "beep" sound is emitted.
8
Change the remote operator setting and reset the
OT (over travel) signal.
The procedure is as follows:
Repeat pushing
until the right screen appears.
Push the
once so that the right screen will appear.
Push the
appear.
9
Make the JOG operation function effective using
the remote operator.
Push the
screen appears.
Push the
the right screen will appear.
,
keys
,
key twice and the
key so that the right screen will
key a few times until the right
1
and
keys in that order so that
2
and
or
1
key
6-10
Push〔MODE〕key
*Para. Set3
1
Func0 : 00000000
*Para. Set3
1
Func0 : 00100000
Completed 1
Func0 : 00100000
WR
*Para. Set3
7
Func6 : 00000000
*Para. Set3
7
Func6 : 01000000