5. INSTALLATION
•
When the connector (lead outlet) cannot be installed with its end downward by any means, slacken
the cable so that water (oil) may not invade it.
•
Make the oil level of the gear box lower than the oil seal lip.
•
Provide a vent to prevent the internal pressure of the gear box from rising.
Slackness
● Connection to the opposite machine
•
Perform centering accurately between the motor shaft and the opposite machine as in Fig. 5-8.
Note that when a rigid coupling is used, especially, a slight offset will lead to damage of the output
shaft.
Oil level
Oil seal lip
Fig. 5-7
The difference between the maximum and
minimum after measuring four points on the
entire circumference is 3/100 mm or less
(when rotated together with the coupling).
Fig. 5-8 Centering
5 - 6
Gear
External
diameter of
the shaft
Motor