10. INTERNATIONAL STANDARDS
10.2.5 Wiring
1. The motor power line shall be clamped on both the control panel and Servomotor sides.
2. The sensor signal line shall be clamped on both the control panel and the Servomotor sides.
3. Perform wiring of the motor power and sensor signal lines separately.
Motor power line
Clamp
Clamp
Sensor signal line
4. Install the clamp with a metal screw directly using a metal conductive P or U clip.
5. Do not clamp by soldering the power line to the shield.
○
×
U or P clip
Soldering
10-7