Vlan - Cisco ASR 9000 Series Reference Manual

Multiple Spanning Tree Protocol Commands

vlan

To enable a PVST or PVRST VLAN instance on the interface and enter PVSTAG or PVRSTAG VLAN
configuration mode, use the vlan command in PVSTAG or PVRSTAG configuration submode.
vlan vlan-id
Syntax Description
vlan-id
Command Default
None
Command Modes
PVRSTAG interface configuration, PVSTAG interface configuration
Command History
Release
Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
ethernet-services
Examples
The following example shows how to enable a VLAN in the PVSTAG configuration mode:
RP/0/RSP0/CPU0:router(config)# spanning-tree pvstag A
RP/0/RSP0/CPU0:router(config-pvstag)# interface GigabitEthernet 0/3/03
RP/0/RSP0/CPU0:router(config-pvstag-if)# vlan 100
RP/0/RSP0/CPU0:router(config-pvstag-if-vlan)#
Related Commands
Command
debug spanning-tree pvrstag packet, on
page 489
Specifies the VLAN identifier. The range of the VLAN ID is between 1 to 4094.
Note There is a limit of 200 VLANs per physical interface and 16000 VLANs across
the system.
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
Modification
This command was introduced.
Operations
read, write
Description
Enables packet debugging for sent and received PVRSTAG
packets.
vlan
6.1.x
639