Bridge Group (Vpls) - Cisco ASR 9000 Series Reference Manual

bridge group (VPLS)

bridge group (VPLS)

To create a bridge group so that it can contain bridge domains and then to assign network interfaces to the
bridge domain, use the bridge group command in L2VPN configuration mode. To remove all the bridge
domains that are created under this bridge group and to remove all network interfaces that are assigned under
this bridge group, use the no form of this command.
bridge group bridge-group-name
no bridge-group bridge-group-name
Syntax Description
bridge-group-name
Command Default
No bridge group is created.
Command Modes
L2VPN configuration
Command History
Release
Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the bridge group command to enter L2VPN bridge group configuration mode.
Task ID
Task ID
l2vpn
Examples The following example shows that bridge group 1 is assigned:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group 1
RP/0/RSP0/CPU0:router(config-l2vpn-bg)#
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
242
Number of the bridge group to which the interface belongs.
Modification
This command was introduced.
Operations
read, write
Multipoint Layer 2 Services Commands