Multipoint Layer 2 Services Commands
neighbor (VPLS)
To add an access pseudowire port to a bridge domain or a pseudowire to a bridge virtual forwarding interface
(VFI), use the neighbor command in the appropriate L2VPN bridge group bridge domain configuration
submode. To remove the pseudowire either from the bridge or from the VFI, use the no form of this command.
neighbor A.B.C.D pw-id value
no neighbor A.B.C.D pw-id value
Syntax Description
A.B.C.D
pw-id value
Command Default
None
Command Modes
L2VPN bridge group bridge domain configuration
L2VPN bridge group bridge domain VFI configuration
Command History
Release
Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the neighbor command to enter L2VPN bridge group bridge domain VFI pseudowire configuration
mode. Alternatively, use the neighbor command to enter L2VPN bridge group bridge domain access pseudowire
configuration mode.
Task ID
Task ID
l2vpn
Examples
The following example shows how to configure an access pseudowire directly under a bridge domain in
L2VPN bridge group bridge domain configuration mode:
RP/0/RSP0/CPU0:router# configure
IP address of the cross-connect peer.
Configures the pseudowire ID and ID value. Range is 1 to 4294967295.
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
Modification
This command was introduced.
Operations
read, write
neighbor (VPLS)
6.1.x
293