Cisco ASR 9000 Series Reference Manual page 668

ethernet-service access-group
Examples The following example show how to apply filters on packets inbound and outbound from GigabitEthernet
interface 0/2/0/0:
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/2/0/2
RP/0/RSP0/CPU0:router(config-if)# ethernet-service access-group p-ingress-filter ingress
RP/0/RSP0/CPU0:router(config-if)# ethernet-service access-group p-egress-filter egress
Related Commands
Command
copy access-list ethernet-service, on page 648
deny (ES ACL), on page 650
ethernet-services access-list, on page 655
permit (ES ACL), on page 657
resequence access-list ethernet-service, on page
660
show access-lists ethernet-services, on page 662
show access-lists ethernet-services trace, on
page 666
show access-list ethernet-service usage pfilter,
on page 668
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
654
Description
Creates a copy of an existing Ethernet services access list.
Sets conditions for an Ethernet services access list
Defines an Ethernet services (Layer 2) access list by name.
Sets conditions for an Ethernet services access list.
Renumbers existing statements and increment subsequent
statements to allow a new Ethernet services access list
statement.
Displays the contents of current Ethernet services access
lists.
Displays Ethernet services access list trace information.
Identifies the modes and interfaces on which a particular
ACL is applied.
Layer 2 Access List Commands