Interface (Pvrst) - Cisco ASR 9000 Series Reference Manual

Multiple Spanning Tree Protocol Commands

interface (PVRST)

To enable and configure Per VLAN Rapid Spanning Tree (PVRST) on an interface, use the interface command
in PVRST configuration mode. To disable PVRST, use the no form of this command.
interface {Bundle-Ether| FastEthernet| FortyGigE| GigabitEthernet| HundredGigE| TenGigE}[guard|
hello-time| link-type| portfast| vlan]
no interface {Bundle-Eher| FastEthernet| FortyGigE| GigabitEthernet| HundredGigE| TenGigE}[guard|
hello-time| link-type| portfast| vlan]
Syntax Description
Bundle-Ether
FastEthernet
FortyGigE
GigabitEthernet
HundredGigE
TenGigE
guard
hello-time
link-type
portfast
vlan
Command Default
None
Command Modes
PVRST configuration
Command History
Release
Release 5.1
Specifies Aggregated Ethernet interface.
Specifies FastEthernet/IEEE 802.3 interface.
Specifies FortyGigabitEthernet or IEEE 802.3 interface.
Specifies GigabitEthernet or IEEE 802.3 interface.
Specifies HundredGigabitEthernet or IEEE 802.3 interface.
Specifies TenGigabitEthernet or IEEE 802.3 interface.
Specifies bridge guard features.
Specifies Hello-Time interface.
Specifies the link type of an interface.
Specifies Portfast for an interface.
Specifies VLAN configuration for an interface.
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
Modification
This command was introduced.
interface (PVRST)
6.1.x
527