Sequencing (L2Vpn) - Cisco ASR 9000 Series Reference Manual

sequencing (L2VPN)

sequencing (L2VPN)

To configure L2VPN pseudowire class sequencing, use the pw-class sequencing command in L2VPN
pseudowire class encapsulation mode. To return to the default behavior, use the no form of this command.
sequencing {both| receive| transmit {resynch 5-65535}}
no sequencing {both| receive| transmit {resynch 5-65535}}
Syntax Description
both
receive
transmit
resynch 5-65535
Command Default
None
Command Modes
L2VPN pseudowire class encapsulation mode
Command History
Release
Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Do not configure sequence resynch on high speed circuits. On low speed circuits, do not configure a threshold
lower than 10 to 20 seconds of traffic.
This command is not supported on the Cisco ASR 9000 Series Aggregation Services Router.
Note
Note All L2VPN configurations can be deleted using the no l2vpn command.
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
138
Configures transmit and receive side sequencing.
Configures receive side sequencing.
Configures transmit side sequencing.
Configures the threshold for out-of-sequence packets before
resynchronization. Range is 5 to 65535.
Modification
This command was introduced.
Point to Point Layer 2 Services Commands