Anycast Source-Interface Loopback - Cisco ASR 9000 Series Reference Manual

anycast source-interface loopback

anycast source-interface loopback
To configure the anycast mode parameters for the VXLAN Tunnel EndPoint (VTEP), use the anycast
source-interface loopback command in interface configuration submode.
anycast source-interface loopback loopback-interface-identifier sync-group ip-address
Syntax Description
anycast
source-interface loopback
loopback-interface-identifier
sync-group ip-address
Command Default
None
Command Modes
Interface configuration submode
Command History
Release
Release 5.3.1
Usage Guidelines
No specific guidelines impact the use of this command.
Examples This example shows how to configure anycast mode parameters for VTEP.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface nve 45
RP/0/RSP0/CPU0:router(config-if)# overlay-encapsulation vxlan
RP/0/RSP0/CPU0:router(config-if)# source-interface loopback 0
RP/0/RSP0/CPU0:router(config-if)# member vni 1 mcast-group 192.20.9.2 0.0.0.0
RP/0/RSP0/CPU0:router(config-if)# anycast source-interface loopback 0 sync-group 192.20.9.2
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
672
Configures the anycast mode parameters for the VTEP.
Configures loopback interface as the source interface for the VTEP.
The variable loopback-interface-identifier is the loopback interface
instance.
Assigns a bidirectional multicast group for synchronization between
anycast gateways.
Modification
This command was introduced.
VXLAN Commands