Flushagain - Cisco ASR 9000 Series Reference Manual

flushagain

flushagain
To configure the MAC flush again timer, use the flushagain command in the EVPN Interface Timers
configuration or in the EVPN Timers configuration mode. To reset the MAC flushagain timer, use the no
form of this command.
flushagain seconds
no flushagain seconds
Syntax Description
seconds
Command Default
None.
Command Modes
EVPN Interface Timers configuration
EVPN Timers configuration
Command History
Release
Release 4.3.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
l2vpn
Examples This example shows how to configure the MAC flushagain timer in the EVPN Interface Timers configuration
mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# evpn
RP/0/RSP0/CPU0:router(config-evpn)# interface bundle-ether 1
RP/0/RSP0/CPU0:router(config-evpn-ac)# timers
RP/0/RSP0/CPU0:router(config-evpn-ac-timers)# flushagain 20
RP/0/RSP0/CPU0:router(config-evpn-ac-timers)#
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
404
Specifies the value in seconds ranging from 0 to 120 seconds. The default value
is 60 seconds.
Modification
This command was introduced.
Operation
read, write
Provider Backbone Bridge Commands