Load-Balancing Flow - Cisco ASR 9000 Series Reference Manual

load-balancing flow

load-balancing flow

To enable all bundle EFPs and PW to use either L2 flow based or L3 flow based balancing, use the
load-balancing flow command in L2VPN configuration mode.
load-balancing flow [src-dst-mac| src-dst-ip]
Syntax Description
src-dst-mac
src-dst-ip
Command Default
The default load balancing is based on the source and destination MAC addresses.
Command Modes
L2VPN configuration
Command History
Release
Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
l2vpn
Examples The following example shows how to set the L3 flow based load balancing:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# load-balancing flow src-dst-ip
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
102
Enables global flow load balancing hashed on source and destination MAC
addresses.
Enables global flow load balancing hashed on source and destination IP
addresses.
Modification
This command was introduced.
Operations
read, write
Point to Point Layer 2 Services Commands