Ethernet Source Bypass Egress-Filter - Cisco ASR 9000 Series Reference Manual

ethernet source bypass egress-filter

ethernet source bypass egress-filter
To mark all ingress packets, received on the interface, to indicate that the packets should bypass any strict
egress filter on any egress interface, use the ethernet source bypass egress-filter command in the subinterface
configuration mode. To allow packets without being marked, use the no form of this command.
ethernet source bypass egress-filter
no ethernet source bypass egress-filter
This command has no keywords or arguments.
Command Default
None
Command Modes
Subinterface configuration
Command History
Release
Release 3.9.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
interface
Examples The following example shows how to mark all ingress packets received on the interface:
RP/0/RSP0/CPU0:router(config)# interface GigabitEthernet0/0/0/0/3.1 l2transport
RP/0/RSP0/CPU0:router(config-subif)# encapsulation dot1q 1
RP/0/RSP0/CPU0:router(config-subif)# rewrite ingress tag translate 1-to-1 dot1q 4094 symmetric
RP/0/RSP0/CPU0:router(config-subif)# ethernet egress-filter disabled
RP/0/RSP0/CPU0:router(config-subif)# ethernet source-bypass-egress-filter
Related Commands
Command
encapsulation dot1q, on page 8
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
20
Modification
This command was introduced.
Operations
read, write
Description
Defines the matching criteria to map 802.1Q frames ingress on an
interface to the appropriate service instance.
Ethernet Interfaces Commands