Interworking Ipv4 - Cisco ASR 9000 Series Reference Manual

Point to Point Layer 2 Services Commands

interworking ipv4

To configure IPv4 interworking, use the interworking ipv4 command in the p2p configuration submode. To
return to the default behavior, use the no form of this command.

interworking ipv4

no interworking ipv4
Syntax Description
ipv4
Command Default
None
Command Modes
p2p configuration submode
Command History
Release
Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
l2vpn
Examples The following example shows how to configure an attachment circuit on a TenGigE interface:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group gr1
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p gr1
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interworking ipv4
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)#
Related Commands
Command
p2p, on page 134
Sets IPv4 interworking.
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
Modification
This command was introduced.
Operations
read, write
Description
Enters p2p configuration submode to configure point-to-point
cross-connects.
interworking ipv4
6.1.x
85