L2Transport (Ethernet) - Cisco ASR 9000 Series Reference Manual

Ethernet Interfaces Commands

l2transport (Ethernet)

To enable Layer 2 transport port mode on an Ethernet interface and enter Layer 2 transport configuration
mode, use the l2transport command in interface configuration mode for an Ethernet interface. To disable
Layer 2 transport port mode on an Ethernet interface, use the no form of this command.
l2transport
no l2transport
This command has no keywords or arguments.
Command Default
None
Command Modes
Interface configuration
Command History
Release
Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
When you issue the l2transport command in interface configuration mode, the CLI prompt changes to
"config-if-l2," indicating that you have entered the Layer 2 transport configuration submode. In the following
sample output, the question mark (?) online help function displays all the commands available under Layer
2 transport configuration submode for an Ethernet interface:
RP/0/RSP0/CPU0:router#configure
RP/0/RSP0/CPU0:router(config)# interface GigabitEthernet 0/1/5/0
RP/0/RSP0/CPU0:router(config-if)# l2transport
RP/0/RSP0/CPU0:router(config-if-l2)# ?
commit
describe
do
exit
no
service-policy
show
RP/0/RSP0/CPU0:router(config-if-l2)#
The l2transport command is mutually exclusive with any Layer 3 interface configuration.
Note
Commit the configuration changes to running
Describe a command without taking real actions
Run an exec command
Exit from this submode
Negate a command or set its defaults
Configure QoS Service policy
Show contents of configuration
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
Modification
This command was introduced.
l2transport (Ethernet)
6.1.x
23