Interface (Vpls) - Cisco ASR 9000 Series Reference Manual

Multipoint Layer 2 Services Commands

interface (VPLS)

To add an interface to a bridge domain that allows packets to be forwarded and received from other interfaces
that are part of the same bridge domain, use the interface command in L2VPN bridge group bridge domain
configuration mode. To remove an interface from a bridge domain, use the no form of this command.
interface type interface-path-id
no interface type interface-path-id
Syntax Description
type
interface-path-id
Command Default
None
Command Modes
L2VPN bridge group bridge domain configuration
Command History
Release
Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the interface command to enter L2VPN bridge group bridge domain attachment circuit configuration
mode. In addition, the interface command enters the interface configuration submode to configure parameters
specific to the interface.
By default, an interface is not part of a bridge.
Task ID
Task ID
l2vpn
Interface type. For more information, use the question mark (?) online help function.
Physical interface or virtual interface.
Note Use the show interfaces command to see a list of all interfaces currently
configured on the router.
For more information about the syntax for the router, use the question mark (?) online
help function.
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
Modification
This command was introduced.
Operations
read, write

interface (VPLS)

6.1.x
267