Tos (L2Vpn) - Cisco ASR 9000 Series Reference Manual

Point to Point Layer 2 Services Commands

tos (l2vpn)

To configure Type of Service (TOS) reflection or to set TOS value, use the tos command in L2VPN pseudowire
class encapsulation L2TPv3 configuration mode. To reset the TOS value, use the no form of this command.
tos {reflect [value tos value]| value tos value [reflect]}
no tos {reflect [value tos value]| value tos value [reflect]}
Syntax Description
reflect
value
tos value
Command Default
By default, the TOS is copied over, from the class of service (COS) fields of the VLAN header. If the underlying
packet is not an IPv4 or IPv6 packet, the COS fields are copied from the VLAN header, even if TOS reflection
is configured.
Command Modes
L2VPN pseudowire class encapsulation L2TPv3 configuration
Command History
Release
Release 4.3.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
All L2VPN configurations can be deleted using the no l2vpn command.
Note
Task ID
Task ID
l2vpn
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
Enables TOS reflection.
Sets the TOS value for L2TPv3 pseudowire class.
Value of the TOS.
Modification
This command was introduced
Operation
read, write
tos (l2vpn)
6.1.x
219