Cisco Asr 9000 Series Aggregation Services Router Vpn And Ethernet Services Command Reference, Release - Cisco ASR 9000 Series Reference Manual

Point to Point Layer 2 Services Commands
The following sample output is from the show l2vpn forwarding command:
RP/0/RSP0/CPU0:router# show l2vpn forwarding location 0/2/cpu0
ID Segment 1
-----------------------------------
1 Gi0/2/0/0 1
The following sample output shows the MAC information in the layer2_fib manager summary:
RP/0/RSP0/CPU0:router# show l2vpn forwarding summary location 0/3/CPU0
Major version num:1, minor version num:0
Shared memory timestamp:0x66ff58e894
Number of forwarding xconnect entries:2
Up:1
AC-PW:0
Number of xconnects down due to:
AIB:0
Number of nexthops:1
Number of static macs: 5
Number of locally learned macs: 5
Number of remotely learned macs: 0
Number of total macs: 10
This example shows the sample output of a configured flow label:
RP/0/RSP0/CPU0:router# show l2vpn for 0/0/cPU0
Local interface: GigabitEthernet0/0/1/1, Xconnect id: 0x1000002, Status: up
Segment 1
AC, GigabitEthernet0/0/1/1, Ethernet port mode, status: Bound
Segment 2
MPLS, Destination address: 3.3.3.3, pw-id: 2, status: Bound, Active
Pseudowire label: 16004
Backup PW
MPLS, Destination address: 2.2.2.2, pw-id: 6, status: Bound
Pseudowire label: 16000
Flow label enabled
Xconnect id: 0xff000014, Status: down
Segment 1
MPLS, Destination address: 2.2.2.2, pw-id: 1, status: Not bound
Pseudowire label: UNKNOWN
Flow label enabled
Segment 2
Bridge id: 0, Split horizon group id: 0
Storm control: disabled
MAC learning: enabled
MAC port down flush: enabled
Flooding:
Broadcast & Multicast: enabled
Unknown unicast: enabled
MAC aging time: 300 s, Type: inactivity
MAC limit: 4000, Action: none, Notification: syslog
MAC limit reached: no
Security: disabled
DHCPv4 snooping: profile not known on this node, disabled
IGMP snooping profile: profile not known on this node
Router guard disabled
This example shows sample output for the show l2vpn forwarding location command:
RP/0/RSP0/CPU0:router# show l2vpn forwarding location 0/1/CPU0
LC/0/1/CPU0:JSegment 1
------------------------------------ ------------------------------------ ---
PBB Edge
Gi0/1/0/1.1(Eth VLAN)
Gi0/1/0/1.2(Eth VLAN)
mpls
PBB Core
Segment 2
1.1.1.1
Down:0
AC-AC:0 AC-BP:1 PW-BP:1
L2VPN:0 L3FIB:0
Control word disabled
Control word disabled
1.2.3.4,22

Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release

9)
Segment 2
Bridge id 0, SHG id 0
Bridge id 0, SHG id 0
Bridge id 0, SHG id 0
Bridge id 1, SHG id 0
Bridge id 2, SHG id 0
show l2vpn forwarding
State
UP
UP
UP
DN
UP
6.1.x
177