Neighbor Routed - Cisco ASR 9000 Series Reference Manual

neighbor routed

neighbor routed

To enable pseudowire routing configuration submode for the p2p cross-connect, use the neighbor routed
command in the p2p configuration submode.
neighbor routed global-id:prefix:ac-id source ac-id
Syntax Description
global-id
prefix
ac-id
source ac-id
Command Default
None
Command Modes
p2p configuration submode
Command History
Release
Release 5.1.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
l2vpn
Examples
The following example shows how to enable pseudowire routing configuration submode for the p2p
cross-connect.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group pw-he1
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p pw-ss
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface gigabitethernet 0/1/0/9
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor routed 100:2.2.2.2:10 source 10
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p-pwr)# pw-class dynamic_sspw
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
118
Targeted remote autonomous system number.
Targeted remote PE IP address.
Specifies the targeted remote attachment circuit id.
Specifies the local attachment circuit ID.
Modification
This command was introduced.
Operation
read, write
Point to Point Layer 2 Services Commands