Programming - Cisco ASR 9000 Series Reference Manual

Provider Backbone Bridge Commands

programming

To configure the programming timer, use the programming command in the EVPN Timers configuration
mode. To delete the programming timer, use the no form of this command.
programming microseconds
no programming microseconds
Syntax Description
microseconds
Command Default
None.
Command Modes
EVPN Timers configuration
Command History
Release
Release 4.3.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Every time the ES Manager runs DF election, it starts a programming timer to account for the time needed
by the hardware to apply the new carving. At the expiry time, the next ES route object is processed or carved,
restarting the timer.
Task ID
Task ID
l2vpn
Examples This example shows how to configure the programming timer in the EVPN Timers configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# evpn
RP/0/RSP0/CPU0:router(config-evpn)# timers
RP/0/RSP0/CPU0:router(config-evpn-timers)# programming 5000
RP/0/RSP0/CPU0:router(config-evpn-timers)#
Specifies the value in microseconds ranging from 0 to 100000 seconds. The
default value is 1500 microseconds.
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
Modification
This command was introduced.
Operation
read, write
programming
6.1.x
425