Logging (L2Vpn) - Cisco ASR 9000 Series Reference Manual

logging (l2vpn)

logging (l2vpn)

To enable cross-connect logging, use the logging command in L2VPN configuration submode. To return to
the default behavior, use the no form of this command.
logging pseudowire status
no logging pseudowire status
Syntax Description
pseudowire status
Command Default
None
Command Modes
L2VPN configuration submode
Command History
Release
Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Note All L2VPN configuration can be deleted using the no l2vpn command.
Task ID
Task ID
l2vpn
Examples The following example shows how to enable cross-connect logging:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# logging pseudowire status
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
106
Point to Point Layer 2 Services Commands
Enables pseudowire state change logging.
Modification
This command was introduced.
Operations
read, write