Spanning-Tree Repag - Cisco ASR 9000 Series Reference Manual

Multiple Spanning Tree Protocol Commands

spanning-tree repag

To enter the Resilient Ethernet Protocol Access Gateway (REPAG) configuration submode, use the
spanning-tree repag command in global configuration mode.
spanning-tree repag protocol instance identifier
Syntax Description
protocol instance identifier
Command Default
None
Command Modes
Global configuration
Command History
Release
Release 3.7.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Refer to the Implementing Multiple Spanning Tree Protocol module of the Cisco ASR 9000 Series Aggregation
Services Router L2VPN and Ethernet Services Configuration Guide for more information.
Task ID
Task ID
interface
Examples The following example shows how to enter the REPAG configuration mode:
RP/0/RSP0/CPU0:router(config)# spanning-tree repag a
RP/0/RSP0/CPU0:router(config-repag)#
Related Commands
Command
debug spanning-tree repag packet, on page
493
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
String of a maximum of 255 characters that identifies the protocol
instance.
Modification
This command was introduced.
Operations
read, write
Description
Enables Resilient Ethernet Protocol (REP) Access Gateway
debugging commands.
spanning-tree repag
6.1.x
633